You can modify the passwords under 8 groups to open the door. The default password value is 0 for all groups, which means passwords are disabled. This device supports 8 passwords, each password has a Group ID ranging from 1-8. IDs of to-be-registered cards must be consecutive numbers.ฤก.3 Register Eight Passwords for Opening the Door You must clear all the registered users before registering cards in batches.Press to reenter the total number of cards. For numbers with less than three digits, press (#1 to confirm. In the process of entering the total number of cards, three-digit numbers are automatically verified.Register Cards in Batches (optional functions) If you fail in swiping the card, pressing fingerprint, or entering your user ID three times, the device will enter the standby state. When the Indicator turns green, you can register the user again. The registration fails if the user ID, fingerprint, or card has been registered (the Indicator turns red and makes three short beeps).It continues to register a new one once a user is successfully registered. If the user ID is not available, the ID number increases automatically.Press to confirm after the user ID is entered.Register the fingerprint or card of a user or register cards in batches. Note: The initial administrator password is 1234. If the administrator password is forgotten, please dismantle the device and wait 30 seconds when there is a short beep, then press the Tamper Switch three times to reset to the initial administrator password, note this operation must be done within 30 seconds. Note: This function can be used to open the door. Open the Door by Entering the Administrator Password You are advised to change the initial password at the beginning. To ensure the data security of the device, you can operate the device only after the administrator password is authenticated.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |